Power Bank for Makita/Dewalt/Milwaukee 18V Lithium Batteries Dual Charging & 9-30V DC/XT60/USB-C with Digital Display

🛠️ Product Usage Instructions

Fit this adapter firmly onto your For Makita/Dewalt/Milwaukee 18V/20V lithium battery to gain multi-port power expansion instantly.

DC & XT60 ports support bidirectional input & output, realizing battery charging and external device power supply at the same time.

USB & Type-C ports provide high-speed fast charging output only, for powering phones, tablets and portable electronics.

Built-in real-time voltage display accurately monitors battery status, supports 2.4V-30V voltage detection for fault checking.

Works with external 9-30V power input to run independently without tool batteries, ideal for construction sites, vehicle and home emergency scenarios.

Supports dual-battery simultaneous charging, and stable charging-while-using operation for DC power tools, RC models, fans and DIY equipment.

⚠️ Safety Precautions

Do not exceed the rated 30V maximum voltage during connection, avoid reverse polarity wiring to prevent short circuit damage.

Keep the adapter away from water, moisture, dust and flammable dangerous environments to avoid safety hazards.

Do not block port heat dissipation, stop use immediately if overheating, and cool down fully before restarting.

Unplug all loads and separate the adapter from battery when stored for a long time, to prevent battery over-discharge damage.

Do not use ports beyond their rated functions: USB/Type-C cannot be used as power input charging ports.

Package includes: 1*Adapter (without battery)

Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.